草莓污视频导航

Location: Mechanical Engineering Building, Room 506
Program number: 403.220.4153/3541
Fax: 403.282.8406
Email address: gradenme@ucalgary.ca
Web page URL:

Doctor of Philosophy (PhD)
Master of Science (MSc) thesis-based
Master of Engineering (MEng), thesis and course-based

The MEng program may be completed on a full-time or a part-time basis.

Specializations:

• Pipeline Engineering
• Engineering, Energy & Environment (Interdisciplinary Specialization)*
• Environmental Engineering (Interdisciplinary Specialization)*
• Energy & Environmental Systems (Interdisciplinary, thesis-based only)*

Further information on the Pipeline Engineering specialization may be found at . See section 15 for other supported areas of research.

* See the Calendar section under Interdisciplinary Specializations for further information.

In addition to the Faculty of Graduate Studies and the Schulich School of Engineering minimum requirements, the Department鈥檚 requirements are as follows:

Master鈥檚 Programs (MSc and MEng)

a) BSc degree or equivalent.

b) A minimum admission grade point average of 3.00 on a four-point scale or equivalent.

c) The admission requirements for both the MEng program and MSc program are the same.

Doctor of Philosophy

See "Engineering Programs鈥�.

Deadlines for submission of complete applications (review of applications received after the deadline is not guaranteed):

International Applicants and Domestic Applicants (Canadian Citizens and Permanent Residents) with consideration of financial support:

January 15 for September admission
May 1 for January admission

Applicants who meet this deadline will be considered for entrance scholarships.

Domestic Applicants (Canadian Citizens and Permanent Residents) without financial support:

June 1 for September admission
October 1 for January admission

See "Engineering Programs".

In addition to Faculty of Graduate Studies and the Schulich School of Engineering minimum requirements, the Department requires:

Master of Engineering (course-based)

Thirty units (5.0 full-course equivalents), no more than 12 units (2.0 full-course equivalents) of which can be senior undergraduate courses (500-level).

Master of Engineering (thesis-based)

a) At least 15 units (2.5 full-course equivalents), of which 6 units (1.0 full-course equivalent) may be taken from outside the Department. No more than 3 units (0.5 full-course equivalent) can be a senior undergraduate course (500-level).

b) In addition to the 15 units (2.5 full-course equivalents), thesis-based students must also receive credit in ENME/ENMF 613 Research Seminar. To receive credit in this course, students must attend designated seminars and present once at the annual Mechanical Engineering Graduate Student Conference in the Winter Term.

Master of Science

a) At least 15 units (2.5 full-course equivalents), of which 6 units (1.0 full-course equivalent) may be taken from outside the Department. Not more than 3 units (0.5 full-course equivalent) can be a senior undergraduate course (500-level).

b) One course to be selected from Mechanical Engineering 631 - Numerical Methods for Engineers or Mechanical Engineering 633 - Mathematical Techniques for Engineers.

c) In addition to the 15 units (2.5 full-course equivalents), thesis-based students must also receive credit in ENME/ENMF 613 Research Seminar. To receive credit in this course, students must attend designated seminars and present once at the annual Mechanical Engineering Graduate Student Conference in the Winter Term.

Doctor of Philosophy

a) Twenty-one to 30 units (3.5 to 5.0 full-course equivalents) at the graduate level, of which 6 units (1.0 full-course equivalent) may be taken from outside the Department. No more than 3 units (0.5 full-course equivalent) can be a senior undergraduate course (500-level).

(For students who transfer from an MSc program, 6 to 18 units (1.0 to 3.0 full-course equivalents) beyond the master's degree are required.)

b) One course to be selected from Mechanical Engineering 631 鈥� Numerical Methods for Engineers or Mechanical Engineering 633 鈥� Mathematical Techniques for Engineers.

c) In addition, thesis-based students must also receive credit in ENME/ENMF 713 Research Seminar. To receive credit in this course, students must attend designated seminars and present one at the annual Mechanical Engineering Graduate Student Conference in the Winter Term.

d) One additional presentation at the Mechanical Engineering Graduate Student Conference in the Winter Term must be completed in partial fulfillment of the degree requirement.

Note: Further details of Departmental requirements are listed in the Department's Graduate Studies Guidebook.

None.

See Section 5 for details.

See "Engineering Programs".

MEng students in the department require a supervisor. See "Engineering Programs".

See "Engineering Programs".

In addition to the Faculty of Graduate Studies and Schulich School of Engineering requirements, the program requires:

Thesis Examination

Scheduling of the Examination

All members of the Supervisory Committee must have reviewed the student鈥檚 draft thesis document before an examination can be scheduled.

Composition of the Committee

The Internal Examiner must be external to the home program.

None beyond the Faculty of Graduate Studies requirements.

None.

The MEng program is self-funded.

See "Engineering Programs".

Students may hire an editor to copyedit their theses subject to the conditions outlined in Section 1.7 of the Faculty of Graduate Studies Thesis/Dissertation Guidelines.

See "Engineering Programs".

Research is supported in the following areas: applied mechanics, automation, control, robotics and nano MEMS, biomechanics, design, manufacturing systems, materials and manufacturing processes, thermo-fluids, energy systems and environment.

Active research programs and research interests of current faculty can be found at .